Sea Clear Power Wiring Harness with Switch

Description

The Sea Clear Power Wiring Harness with Switch & Jumper is the first wiring harness ever made for the sole purpose of wiring up all of your marine electronics. Tired of poor image quality? Tired of your units blinking? Tired of your units and accessories not being on one system? Tired of waiting on your units taking 30 seconds to start reading structure scan after coming off pad?  Pick up a Sea Clear Power Wiring Harness with Switch & Jumper today to solve all these problems with clean power and “sea” the difference.

Compatible with all brands and accessories including Humminbird, Garmin, and Lowrance, the Sea Clear wiring system allows you to tie all of your graphs and electronics into one harness.  You will need to purchase fuse holders to complete installation. Ttypically you will need one (1) fuse holder for every electronic device you add to the circuit. To get the highest performance, Sea Clear recommends using the Sea Clear Inline Corrosion Resistant Fuse Holders, so every processor on your boat gets the clean and adequate power it needs to work properly. Check out the Sea Clear Power Wiring Harness with Switch & Jumper Install Walkthrough in the Product Video section for a full installation breakdown.

Included:
– 26-ft Universal Harness
– Battery Disconnect Switch
– 20-in Jumper Wire

Please Note: You will need to purchase fuse holders to complete installation. Typically you will need one (1) fuse holder for every electronic device you add to the circuit. Sea Clear recommends using the Sea Clear Inline Corrosion Resistant Fuse Holders to ensure clean and adequate power to all processors.

Backed by Sea Clear Power’s Warranty

All warranties must go directly through Sea Clear Power.